When
sending part drawings please be sure to compress them using Winzip
or PKZip.
Zipped files should not exceed 2.5 MB if sent via AOL.
Files
with the following extensions can be imported:
-
Solid
Works part files (.prt; .sldprt)
-
assembly
files (.asm; .sldasm)
-
drawing
files (.drw; slddrw)
-
ProEngineering
part files (.prt)
-
Cadkey
part files (.prt)
-
Parasolid
files (.x_t; x_b), IGES files (.igs;.iges)
-
DXF files
(.dxf),
-
Dwg files
(.dwg)
-
VRML (.vrm)
-
VDAFS
(.vda)
-
ACIS files
(.sat)
-
Add-Ins
(D11)
-
Lib Feat
Part files (.ltp; .sldltp)
-
UG11 files
(.prt)
|
Find
us at: We’re located about 40 miles north
of Boston, MA at the junction of Interstate 95 & 495 near the New Hampshire
border.
From
the south take 95N to exit 58A(route 110 east, Salisbury) Turn
right onto 110E and take your first left (Rabbit Road)at the traffic light,
corner of Donahue Dodge and Riverfront Marine. Industrial Park is
about a mile up on the right. Turn right on Fanaras Drive and we’re
the third building on the left.
From
the north take 95S to exit for route 286 east(Salisbury, the Beaches),
exit goes behind the rest area and is before the 495 and route 110 exits.
Continue over route 95 and take a right at the Mobil gas/convenience store.
Proceed south through the next traffic light about one mile. The
main entrance to the Industrial Park will be on your left and has a large
sign/directory. Turn left on Fanaras Drive and we’re the third building
on the left.
From
the west take 495NE to exit 55(route 110 east Salisbury, route 95S
Boston). This is the last exit prior to merging with 95N. Continue
east on route 110 about 2 miles past some fast food restaurants and then
under route 95. Take a left at the Rabbit Road traffic light, corner
of Donahue Dodge and Riverfront Marine. Industrial Park is about
a mile up on the right. Turn right on Fanaras Drive and we’re the
third building on the left. |
